Tubing & sleeves.

Building your own 750? let us know about your progress. Also in this section: suppliers who can build you a custom 750 - have a chat and see what they can do for you!

Tubing & sleeves.

Postby geofff » Sat Apr 09, 2022 12:52 pm


Just wondered if anyone had any recommendations for suppliers?

I need ID tubing 2.384cm for some engine mount bushes.

Also need to sleeve down some bolt holes from 12.6mm to 11mm.

Any ideas?

I can get access to a lathe at my work, so may end up using that and raiding the offcuts bucket. But I'm quite happy to be lazy and buy off the shelf.


Posts: 191
Joined: Thu Mar 14, 2019 8:43 pm

Re: Tubing & sleeves.

Postby Baggers » Thu Apr 14, 2022 7:44 am

Hi Geoff,

Where I haven't been able to for this, I found the right size OD tube and drilled the inside to the right size. Lathe does make it easier though.

Hope it helps,

Posts: 206
Joined: Sat Nov 23, 2013 8:34 pm

Return to Builder's Garage

Who is online

Users browsing this forum: No registered users and 3 guests